1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. 2. The FAA amends § 39.13 by adding the following new airworthiness directive: 2022-27-02 Bombardier, Inc.: Amendment 39-22287; Docket No. FAA-2022-0684; Project Identifier MCAI-2021-01204-T. (a) Effective Date This airworthiness directive (AD) is effective March 17, 2023. (b) Affected ADs None. (c) Applicability This AD applies to Bombardier, Inc., Model BD-700-2A12 airplanes, certificated in any category, serial numbers 70006 through 70084 inclusive. (d) Subject Air Transport Association (ATA) of America Code 34, Navigation. (e) Unsafe Condition This AD was prompted by a report of a lateral offset observed on the head-up display (HUD) of several airplanes between the synthetic vision system (SVS) and actual runway. The FAA is issuing this AD to address this offset, which could create an incorrect aircraft reference display on the HUD, and lead to excessive deviation during landing, particularly affecting steep approach landing (SAL) or enhanced flight vision system (EFVS) operations. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Revision of the Existing Airplane Flight Manual (AFM) Within 30 days after the effective date of this AD, revise the existing AFM to include the information in the sections of the AFM specified in paragraphs (g)(1) through (3) of this AD. (1) Section 6., Service Bulletins, Chapter 1-Introduction, Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, Revision 18, dated August 18, 2022. Note 1 to paragraph (g)(1): For obtaining the sections and supplements of the Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, specified in paragraphs (g)(1) through (3) of this AD, use Document Identification No. GL 7500 AFM. (2) Supplement 7-Enhanced Flight Vision System (EFVS) Operations, Chapter 7-Supplements, Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, Revision 18, dated August 18, 2022. (3) Supplement 20-Steep Approaches with Published Glidepath Angles from 4.5 to 5.5 Degrees, Chapter 7-Supplements, Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, Revision 18, dated August 18, 2022. (h) Head-Up Display (HUD) Calibration Within 27 months after the effective date of this AD, calibrate the HUD and second HUD (if installed), including a general visual inspection of the HUD mounting brackets and sill beams for damage and contamination ( e.g., drill shavings and adhesive) of the mating surfaces and injection holes, a general visual inspection for voids in the structural adhesive, and applicable corrective actions, in accordance with the Accomplishment Instructions of Bombardier Service Bulletin 700-34-7521, Revision 03, dated July 27, 2021, or Bombardier Service Bulletin 700-34-7521, Revision 04, dated December 6, 2021; and Bombardier Service Bulletin 700-34-7523, Revision 01, dated December 8, 2021; as applicable. All corrective actions must be done before further flight. (i) Credit for Previous Actions (1) This paragraph provides credit for actions required by paragraph (h) of this AD, if those actions were performed before the effective date of this AD using the service information identified in, and meeting the applicable conditions specified in, paragraphs (i)(1)(i) through (iv) of this AD. (i) Credit is allowed for Bombardier Service Bulletin 700-34-7521, dated April 1, 2021 (which is not incorporated by reference in this AD), if the retroactive actions identified in Bombardier Service Bulletin 700-34-7521, Revision 03, dated July 27, 2021, or Bombardier Service Bulletin 700-34-7521, Revision 04, dated December 6, 2021, (which are incorporated by reference in this AD) are done within 27 months after the effective date of this AD. (ii) Credit is allowed for Bombardier Service Bulletin 700-34-7521, Revision 01, dated April 30, 2021 (which is not incorporated by reference in this AD), if the retroactive actions identified in Bombardier Service Bulletin 700-34-7521, Revision 03, dated July 27, 2021, or Bombardier Service Bulletin 700-34-7521, Revision 04, dated December 6, 2021, (which are incorporated by reference in this AD) are done within 27 months after the effective date of this AD. (iii) Credit is allowed for Bombardier Service Bulletin 700-34-7521, Revision 02, dated July 12, 2021 (which is not incorporated by reference in this AD), if the retroactive actions identified in Bombardier Service Bulletin 700-34-7521, Revision 03, dated July 27, 2021, or Bombardier Service Bulletin 700-34-7521, Revision 04, dated December 6, 2021 (which are incorporated by reference in this AD) are done within 27 months after the effective date of this AD. (iv) Credit is allowed for Bombardier Service Bulletin 700-34-7523, dated April 1, 2021 (which is not incorporated by reference in this AD), if the retroactive actions identified in Bombardier Service Bulletin 700-34-7523, Revision 01, dated December 8, 2021 (which is incorporated by reference in this AD), are done within 27 months after the effective date of this AD. (2) This paragraph provides credit for the actions required by paragraph (g) of this AD, if those actions were performed before the effective date of this AD using the service information identified in paragraphs (i)(2)(i) through (xii) of this AD, as applicable. Note 2 to paragraph (i)(2): For obtaining the sections and supplements of the Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, specified in paragraphs (i)(2)(i) through (xii) of this AD, use Document Identification No. GL 7500 AFM. (i) Section 6., Service Bulletins, Chapter 01-Introduction, Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, Revision 14, dated October 21, 2021. (ii) Section 6., Service Bulletins, Chapter 1-Introduction, Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, Revision 15, dated February 3, 2022. (iii) Section 6., Service Bulletins, Chapter 1-Introduction, Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, Revision 16, dated April 26, 2022. (iv) Section 6., Service Bulletins, Chapter 1-Introduction, Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, Revision 17, dated July 14, 2022. (v) Supplement 7-Enhanced Flight Vision System (EFVS) Operations, Chapter 7-Supplements, Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, Revision 14, dated October 21, 2021. (vi) Supplement 7-Enhanced Flight Vision System (EFVS) Operations, Chapter 7-Supplements, Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, Revision 15, dated February 3, 2022. (vii) Supplement 7-Enhanced Flight Vision System (EFVS) Operations, Chapter 7-Supplements, Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, Revision 16, dated April 26, 2022. (viii) Supplement 7-Enhanced Flight Vision System (EFVS) Operations, Chapter 7-Supplements, Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, Revision 17, dated July 14, 2022. (ix) Supplement 20-Steep Approaches with Published Glidepath Angles from 4.5 to 5.5 Degrees, Chapter 7-Supplements, Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, Revision 14, dated October 21, 2021. (x) Supplement 20-Steep Approaches with Published Glidepath Angles from 4.5 to 5.5 Degrees, Chapter 7-Supplements, Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, Revision 15, dated February 3, 2022. (xi) Supplement 20-Steep Approaches with Published Glidepath Angles from 4.5 to 5.5 Degrees, Chapter 7-Supplements, Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, Revision 16, dated April 26, 2022. (xii) Supplement 20-Steep Approaches with Published Glidepath Angles from 4.5 to 5.5 Degrees, Chapter 7-Supplements, Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, Revision 17, dated July 14, 2022. (j) Other FAA AD Provisions The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, New York ACO Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the manager of the certification office, send it to ATTN: Program Manager, Continuing Operational Safety, FAA, New York ACO Branch, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 516-228-7300. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office. (2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, New York ACO Branch, FAA; or Transport Canada; or Bombardier, Inc.'s Transport Canada Design Approval Organization (DAO). If approved by the DAO, the approval must include the DAO-authorized signature. (k) Additional Information (1) For more information about this AD, contact Thomas Niczky, Aerospace Engineer, Avionics and Electrical Systems Section, FAA, New York ACO Branch, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 516-228-7347; email
[email protected]. (2) Service information identified in this AD that is not incorporated by reference is available at the addresses specified in paragraphs (l)(3) and (4) of this AD. (l) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise. (i) Bombardier Service Bulletin 700-34-7521, Revision 03, dated July 27, 2021. (ii) Bombardier Service Bulletin 700-34-7521, Revision 04, dated December 6, 2021. (iii) Bombardier Service Bulletin 700-34-7523, Revision 01, dated December 8, 2021. (iv) Section 6., Service Bulletins, Chapter 01-Introduction, Bombardier Global 7500 Airplane Flight Manual (AFM), Publication No. CSP 700-7000-1, Revision 18, dated August 18, 2022. Note 3 to paragraph (l)(2)(iv): For obtaining the section and supplements of the Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, specified in paragraphs (l)(2)(iv) through (vi) of this AD, use Document Identification No. GL 7500 AFM. (v) Supplement 7-Enhanced Flight Vision System (EFVS) Operations, Chapter 7-Supplements, Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, Revision 18, dated August 18, 2022. (vi) Supplement 20-Steep Approaches with Published Glidepath Angles from 4.5 to 5.5 Degrees, Chapter 7-Supplements, Bombardier Global 7500 AFM, Publication No. CSP 700-7000-1, Revision 18, dated August 18, 2022. (3) For service information identified in this AD, contact Bombardier Business Aircraft Customer Response Center, 400 Côte-Vertu Road West, Dorval, Québec H4S 1Y9, Canada; telephone 1-514-855-2999; email
[email protected]; website bombardier.com . (4) You may view this service information at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. (5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email
[email protected], or go to: www.archives.gov/federal-register/cfr/ibr-locations.html. Issued on December 20, 2022. Christina Underwood, Acting Director, Compliance & Airworthiness Division, Aircraft Certification Service. [FR Doc. 2023-02781 Filed 2-9-23; 8:45 am]BILLING CODE 4910-13-P