1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. § 39.13 [Amended] 2. The FAA amends § 39.13 by adding the following new airworthiness directive: 2022-24-10 MHI RJ Aviation ULC (Type Certificate Previously Held by Bombardier, Inc.): Amendment 39-22250; Docket No. FAA-2022-1154; Project Identifier MCAI-2022-00550-T. (a) Effective Date This airworthiness directive (AD) is effective January 18, 2023. (b) Affected ADs None. (c) Applicability This AD applies to all MHI RJ Aviation ULC Model CL-600-2C10 (Regional Jet Series 700, 701 & 702) airplanes, Model CL-600-2C11 (Regional Jet Series 550) airplanes, Model CL-600-2D15 (Regional Jet Series 705) airplanes, Model CL-600-2D24 (Regional Jet Series 900) airplanes, and Model CL-600-2E25 (Regional Jet Series 1000) airplanes; certificated in any category. (d) Subject Air Transport Association (ATA) of America Code 26, Fire protection. (e) Unsafe Condition This AD was prompted by a report indicating that the pressure switch gauge assembly for the cargo bay fire extinguisher container has the potential to display an incorrect pressure under certain environmental conditions. The FAA is issuing this AD to address instances where the fire extinguisher container capacity is reduced below the level required to appropriately suppress a cargo fire, and the flightcrew does not receive an indication of low pressure, which, in the event of a fire in the cargo bay, could lead to an uncontrollable fire and loss of the airplane. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Replacement Within 10 years after the effective date of this AD: Replace the high rate of discharge and low rate of discharge pressure switch gauge assemblies for any cargo bay fire extinguisher container having part number (P/N) 473919-1, P/N 473920-1, and P/N 474901-1, manufactured prior to March 2020 as indicated on the identification plate, with a serviceable part number, in accordance with the Accomplishment Instructions of MHI RJ Aviation ULC Service Bulletin 670BA-26-013, dated October 8, 2021. (h) Parts Installation Prohibition As of 10 years after the effective date of this AD, or before further flight after the replacement has been done in paragraph (g) of this AD, whichever occurs first, no person may install, on any airplane, a cargo bay fire extinguisher container having P/N 473919-1, P/N 473920-1, or P/N 474901-1, manufactured prior to March 2020 as indicated on the identification plate, unless "CW SB Fire Extinguisher-26-1" is identified on the identification plate. (i) No Return of Part Requirement Although the Accomplishment Instructions of MHI RJ Aviation ULC Service Bulletin 670BA-26-013, dated October 8, 2021, specify to return the cargo fire extinguisher containers to the manufacturer, this AD does not include that requirement. (j) Additional AD Provisions The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, New York ACO Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the manager of the certification office, send it to ATTN: Program Manager, Continuing Operational Safety, FAA, New York ACO Branch, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 516-228-7300. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office. (2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, New York ACO Branch, FAA; or Transport Canada; or MHI RJ Aviation ULC's Transport Canada Design Approval Organization (DAO). If approved by the DAO, the approval must include the DAO-authorized signature. (k) Additional Information (1) For related information, refer to Transport Canada AD CF-2022-20, dated April 19, 2022. This Transport Canada AD may be found in the AD docket at regulations.gov under Docket No. FAA-2022-1154. (2) For more information about this AD, contact Gabriel Kim, Aerospace Engineer, Mechanical Systems and Administrative Services Section, FAA, New York ACO Branch, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 516-228-7300; email
[email protected]. (l) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise. (i) MHI RJ Aviation ULC Service Bulletin 670BA-26-013, dated October 8, 2021. (ii) [Reserved] (3) For service information identified in this AD, contact MHI RJ Aviation Group, Customer Response Center, 3655 Ave. des Grandes-Tourelles, Suite 110, Boisbriand, Québec J7H 0E2 Canada; North America toll-free telephone 833-990-7272 or direct-dial telephone 450-990-7272; fax 514-855-8501; email
[email protected]; website mhirj.com. (4) You may view this service information at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. (5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email
[email protected], or go to: www.archives.gov/federal-register/cfr/ibr-locations.html. Issued on November 15, 2022. Ross Landes, Deputy Director for Regulatory Operations, Compliance & Airworthiness Division, Aircraft Certification Service. [FR Doc. 2022-27019 Filed 12-13-22; 8:45 am]BILLING CODE 4910-13-P