eFlight
FAA orders · airworthiness directive · current

2022-22-11: Flight Control System, Navigation

FAA order 2022-22-11 is an airworthiness directive in force since December 30, 2022. The FAA's subject line: Flight Control System, Navigation. It names Airbus A319, Airbus A320, Airbus A321: about 2,059 aircraft on the U.S. register today across them, though an order usually covers particular versions or serial numbers rather than every one. System: flight controls.

What it applies to as the FAA lists it

Kind of product
Aircraft
Makes
Airbus SAS
Models
A319-151N, A319-153N, A319-171N, A320-251N, A320-252N, A320-253N, A320-271N, A320-272N, A320-273N, A321-251N, A321-251NX, A321-252N, A321-252NX, A321-253N, A321-253NX, A321-271N, A321-271NX, A321-272N, A321-272NX
On this site
Airbus A319 330 registered
Airbus A320 786 registered
Airbus A321 943 registered

Dates and paperwork

In force since
December 30, 2022
Published
November 25, 2022 (signed October 21, 2022)
Docket
FAA-2022-1060
Replaces
2021-14-08
Status
Current
The FAA's document
Read the order on the FAA's site

The FAA's summary their words, unchanged

The FAA is superseding Airworthiness Directive (AD) 2021-14- 08, which applied to all Airbus SAS Model A319-151N, A319-153N, A319- 171N, A320-251N, A320-252N, A320-273N, A321-251N, A321-251NX, A321- 252N, A321-252NX, A321-253N, A321-253NX, A321-271N, A321-271NX, A321- 272N, and A321-272NX airplanes. AD 2021-14-08 required revising the existing airplane flight manual (AFM) to include a procedure to reinforce the airspeed check during the take-off phase and provide instructions to abort take-off in certain cases. This AD was prompted by the development of a software update to the elevator aileron computer (ELAC) to address the unsafe condition. This AD continues to require the actions in AD 2021-14-08 and requires replacing each affected ELAC and removing the AFM revision required by AD 2021-14-08, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. This AD also prohibits the installation of affected parts. The FAA is issuing this AD to address the unsafe condition on these products.

The order itself the regulatory text, as published

Show the full text (6,342 characters)
1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. 2. The FAA amends § 39.13 by: a. Removing Airworthiness Directive (AD) 2021-14-08, Amendment 39-21635 (86 FR 34933, July 1, 2021); and b. Adding the following new AD: 2022-22-11 Airbus SAS: Amendment 39-22226; Docket No. FAA-2022-1060; Project Identifier MCAI-2022-00251-T. (a) Effective Date This airworthiness directive (AD) is effective December 30, 2022. (b) Affected ADs This AD replaces AD 2021-14-08, Amendment 39-21635 (86 FR 34933, July 1, 2021) (AD 2021-14-08). (c) Applicability This AD applies to all Airbus SAS Model airplanes identified in paragraphs (c)(1) through (3) of this AD, certificated in any category. (1) Model A319-151N, -153N, and -171N airplanes. (2) Model A320-251N, -252N, -253N, -271N, -272N, and -273N airplanes. (3) Model A321-251N, -251NX, -252N, -252NX, -253N, -253NX, -271N, -271NX, -272N, and -272NX airplanes. (d) Subject Air Transport Association (ATA) of America Code 27, Flight Control System; 34, Navigation. (e) Unsafe Condition This AD was prompted by reports of an increasing number of operational disruptions due to airspeed discrepancies, and the development of a software update to the elevator aileron computer (ELAC) to address the unsafe condition. The FAA is issuing this AD to address airspeed discrepancies, which could lead to an unstable flight path after take-off, possibly resulting in reduced control of the airplane. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Requirements Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency (EASA) AD 2022-0028, dated February 22, 2022 (EASA AD 2022-0028). (h) Exceptions to EASA AD 2022-0028 (1) Where EASA AD 2022-0028 refers to its effective date, this AD requires using the effective date of this AD. (2) Where EASA AD 2022-0028 refers to June 28, 2021 (the effective date of EASA AD 2021-0150, dated June 21, 2021; corrected June 25, 2021), this AD requires using July 1, 2021 (the effective date of AD 2021-14-08). (3) Paragraph (3) of EASA AD 2022-0028 does not apply to this AD. (4) Where paragraphs (1) and (5) of EASA AD 2022-0028 specify to "inform all flight crews, and, thereafter, operate the aeroplane accordingly," this AD does not require those actions as those actions are already required by existing FAA operating regulations. (5) The "Remarks" section of EASA AD 2022-0028 does not apply to this AD. (i) Additional AD Provisions The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the International Validation Branch, send it to the attention of the person identified in paragraph (j) of this AD. Information may be emailed to: [email protected] . (i) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office. (ii) AMOCs approved previously for AD 2022-14-08 are approved as AMOCs for the corresponding provisions of EASA AD 2022-0028 that are required by paragraph (g) of this AD. (2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, International Validation Branch, FAA; or EASA; or Airbus SAS's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature. (3) Required for Compliance (RC): Except as required by paragraph (i)(2) of this AD, if any service information contains procedures or tests that are identified as RC, those procedures and tests must be done to comply with this AD; any procedures or tests that are not identified as RC are recommended. Those procedures and tests that are not identified as RC may be deviated from using accepted methods in accordance with the operator's maintenance or inspection program without obtaining approval of an AMOC, provided the procedures and tests identified as RC can be done and the airplane can be put back in an airworthy condition. Any substitutions or changes to procedures or tests identified as RC require approval of an AMOC. (j) Additional Information For more information about this AD, contact Dan Rodina, Aerospace Engineer, Large Aircraft Section, FAA, International Validation Branch, 2200 South 216th St., Des Moines, WA 98198; telephone 206-231-3225; email [email protected] . (k) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise. (i) European Union Aviation Safety Agency (EASA) AD 2022-0028, dated February 22, 2022. (ii) [Reserved] (3) For EASA AD 2022-0028, contact EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; telephone +49 221 8999 000; email [email protected]; website easa.europa.eu . You may find this EASA AD on the EASA website at ad.easa.europa.eu . (4) You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. (5) You may view this material that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email [email protected], or go to: www.archives.gov/federal-register/cfr/ibr-locations.html . Issued on October 21, 2022. Christina Underwood, Acting Director, Compliance & Airworthiness Division, Aircraft Certification Service. [FR Doc. 2022-25511 Filed 11-23-22; 8:45 am]BILLING CODE 4910-13-P

Related safety bulletins advice on the same designs, not orders

2019-02-19NE-19-03 · Escape Slide Maintenance Tasks and Intervals - JASC 2565
2014-11-06NM-15-02 · Cabin Equipment/Furnishings
2014-06-03NM-14-21 · Communications: Honeywell RTA 44D VHF Transceivers
2013-03-21NM-13-24 · Air Conditioning System: Air Distribution Fan
2012-10-23NM-13-03 · Hydraulic Power System: Power Transfer Unit

Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of November 19, 2026. Connections as data: /graph/directive/2022-22-11.json · aircraft systems.

Aircraft

By kindModelsMakersEnginesFleetsWhat changed

Fly

Plan a flightAirportsLive mapRoutes and flightsFuels

Training and work

TrainingFlight schoolsGround schoolsPilot examinersMedical examinersJobs

Companies

DirectoryCharter operatorsFBOsRepair stationsClaim your listing

Safety and data

AccidentsRecords checkAnalyticsSAFxCHANGEThe graphAbout

Colours follow your device's light or dark setting.