Adoption of the Amendment \n\n\n\tAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n0 1. The authority citation for part 39 continues to read as follows: \n\n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\n\n\nSec. 39.13 (Amended) \n\n0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive: \n\n2021-10-20 ATR--GIE Avions de Transport R(eacute)gional: Amendment 39-21553; Docket No. FAA-2021-0365; Project Identifier MCAI-2021- 00527-T. \n\n(a) Effective Date \n\n\n\tThis airworthiness directive (AD) becomes effective May 14, 2021. \n\n(b) Affected ADs \n\n\n\tNone. \n\n(c) Applicability \n\n\n\tThis AD applies to ATR--GIE Avions de Transport R(eacute)gional Model ATR42-500 and ATR72-212A airplanes, certificated in any category, as identified in European Union Aviation Safety Agency (EASA) Emergency AD 2021-0120-E, dated May 3, 2021 (EASA Emergency AD 2021-0120-E). \n\n(d) Subject \n\n\n\tAir Transport Association (ATA) of America Code 24, Electrical power. \n\n(e) Reason \n\n\n\tThis AD was prompted by reports of temporary loss of all display units and the integrated electronic standby instrument (IESI). The FAA is issuing this AD to address temporary loss of all display units and the IESI, which could result in loss of control of the airplane. \n\n(f) Compliance \n\n\n\tComply with this AD within the compliance times specified, unless already done. \n\n(g) Requirements \n\n\n\tExcept as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA Emergency AD 2021-0120-E. \n\n(h) Exceptions to EASA Emergency AD 2021-0120-E \n\n\n\t(1) Where EASA Emergency AD 2021-0120-E refers to its effective date, this AD requires using the effective date of this AD. \n\t(2) Paragraph (1) of EASA Emergency AD 2021-0120-E specifies amending ''the applicable AFM (aircraft flight manual),'' but this AD requires amending ''the applicable existing AFM and applicable corresponding operational procedures.'' \n\t(3) Where paragraphs (1) and (2) of EASA Emergency AD 2021-0120- E specify to ''inform all flight crews, and, thereafter, operate the aeroplane accordingly,'' this AD does not require those actions as those actions are already required by existing FAA operating regulations. \n\t(4) Where paragraph (5) of EASA Emergency AD 2021-0120-E specifies actions if ''discrepancies are detected,'' for this AD a ''discrepancy'' is defined as a lack of power supply to DU 4 or a static inverter 1 INV FAULT not being displayed on 29VU. \n\t(5) The ''Remarks'' section of EASA Emergency AD 2021-0120-E does not apply to this AD. \n\t(6) Paragraph(s) (6) and (7) of EASA Emergency AD 2021-0120-E specify to report test results to ATR within a certain compliance time. For this AD, report test results at the applicable time specified in paragraph (h)(6)(i) or (ii) of this AD. \n\t(i) If the test was done on or after the effective date of this AD: Submit the report within 10 days after the test. \n\t(ii) If the test was done before the effective date of this AD: Submit the report within 10 days after the effective date of this AD. \n\n(i) Other FAA AD Provisions \n\n\n\tThe following provisions also apply to this AD: \n\t(1) Alternative Methods of Compliance (AMOCs): The Manager, Large Aircraft Section, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the Large Aircraft Section, International Validation Branch, send it to the attention of the person identified in paragraph (j) of this AD. Information may be emailed to:
[email protected]. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office. \n\t(2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, Large Aircraft Section, International Validation Branch, FAA; or EASA; or ATR--GIE Avions de Transport R(eacute)gional's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature. \n\t(3) Paperwork Reduction Act Burden Statement: A federal agency may not conduct or sponsor, and a person is not required to respond to, nor shall a person be subject to a penalty for failure to comply with a collection of information subject to the requirements of the Paperwork Reduction Act unless that collection of information displays a current valid OMB Control Number. The OMB Control Number for this information collection is 2120-0056. Public reporting for this collection of information is estimated to be approximately 1 hour per response, including the time for reviewing \n\n((Page 26377)) \n\ninstructions, searching existing data sources, gathering and maintaining the data needed, and completing and reviewing the collection of information. All responses to this collection of information are mandatory as required by this AD. Send comments regarding this burden estimate or any other aspect of this collection of information, including suggestions for reducing this burden to Information Collection Clearance Officer, Federal Aviation Administration, 10101 Hillwood Parkway, Fort Worth, TX 76177-1524. \n\n(j) Related Information \n\n\n\tFor more information about this AD, contact Shahram Daneshmandi, Aerospace Engineer, Large Aircraft Section, International Validation Branch, FAA, 2200 South 216th St., Des Moines, WA 98198; telephone and fax 206-231-3220; email
[email protected]. \n\n(k) Material Incorporated by Reference \n\n\n\t(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. \n\t(2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise. \n\t(i) European Union Aviation Safety Agency (EASA) Emergency AD 2021-0120-E, dated May 3, 2021. \n\t(ii) (Reserved) \n\t(3) For EASA Emergency AD 2021-0120-E, contact EASA, Konrad- Adenauer-Ufer 3, 50668 Cologne, Germany; telephone +49 221 8999 000; email
[email protected]; internet www.easa.europa.eu. You may find this EASA AD on the EASA website at https://ad.easa.europa.eu. \n\t(4) You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. This material may be found in the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2021-0365. \n\t(5) You may view this material that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email
[email protected], or go to: https://www.archives.gov/federal-register/cfr/ibr-locations.html. \n\n\n\tIssued on May 5, 2021. Lance T. Gant, Director, Compliance & Airworthiness Division, Aircraft Certification Service. (FR Doc. 2021-10257 Filed 5-11-21; 4:15 pm) BILLING CODE 4910-13-P