eFlight
FAA orders · airworthiness directive · current

2021-08-09: Navigation

FAA order 2021-08-09 is an airworthiness directive in force since April 23, 2021. The FAA's subject line: Navigation. It names Airbus A330: about 153 aircraft on the U.S. register today, though an order usually covers particular versions or serial numbers rather than every one. System: instruments and avionics.

What it applies to as the FAA lists it

Kind of product
Aircraft
Makes
Airbus SAS
Models
A330-323, A330-342, A330-343
On this site
Airbus A330 153 registered

Dates and paperwork

In force since
April 23, 2021
Published
April 8, 2021 (signed April 1, 2021)
Docket
FAA-2021-0266
Status
Current
The FAA's document
Read the order on the FAA's site

The FAA's summary their words, unchanged

The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A330-323, -342, and -343 airplanes. This AD was prompted by the discovery of an erroneous value in some airplane data files that are used for performance computations in the airplane flight manual (AFM). This AD requires revising the existing AFM and applicable corresponding operational procedures, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.

The order itself the regulatory text, as published

Show the full text (6,423 characters)
Adoption of the Amendment \n\n\n\tAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n0 1. The authority citation for part 39 continues to read as follows: \n\n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\n\n\nSec. 39.13 (Amended) \n\n0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive: \n\n2021-08-09 Airbus SAS: Amendment 39-21503; Docket No. FAA-2021-0266; Project Identifier MCAI-2021-00320-T. \n\n(a) Effective Date \n\n\n\tThis airworthiness directive (AD) becomes effective April 23, 2021. \n\n(b) Affected ADs \n\n\n\tNone. \n\n(c) Applicability \n\n\n\tThis AD applies to all Airbus SAS Model A330-323, A330-342, and A330-343 airplanes, certificated in any category. \n\n(d) Subject \n\n\n\tAir Transport Association (ATA) of America Code 34, Navigation. \n\n(e) Reason \n\n\n\tThis AD was prompted by the discovery of an erroneous value in some airplanedata files used for airplane flight manual (AFM) performance computations. The FAA is issuing this AD to prevent the generation of an incorrect displacement drag due to the erroneous value, which could lead to substantially reduced performance of the airplane and possible runway overrun, and consequent damage to the airplane and injury to occupants. \n\n(f) Compliance \n\n\n\tComply with this AD within the compliance times specified, unless already done. \n\n(g) Requirements \n\n\n\tExcept as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency (EASA) AD 2021-0071, dated March 12, 2021 (EASA AD 2021-0071). \n\n(h) Exceptions to EASA AD 2021-0071 \n\n\n\t(1) Where EASA AD 2021-0071 refers to its effective date, this AD requires using the effective date of this AD. \n\t(2) Where paragraph (1) of EASA AD 2021-0071 specifies to ''implement the AFM CP,'' this AD requires revisingthe existing AFM and applicable corresponding operational procedures to include a certification package with the corrected complementary performance data file incorporated into the performance database section. \n\t(3) Whereas paragraph (1) of EASA AD 2021-0071 specifies to ''inform all flight crews, and, thereafter, operate the aeroplane accordingly,'' this AD does not require those actions, which are already required by existing FAA operating regulations. \n\t(4) The ''Remarks'' section of EASA AD 2021-0071 does not apply to this AD. \n\n(i) Other FAA AD Provisions \n\n\n\tThe following provisions also apply to this AD: \n\t(1) Alternative Methods of Compliance (AMOCs): The Manager, Large Aircraft Section, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures \n\n((Page 18183)) \n\nfound in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office,as appropriate. If sending information directly to the Large Aircraft Section, International Validation Branch, send it to the attention of the person identified in paragraph (j) of this AD. Information may be emailed to: [email protected]. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office. \n\t(2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, Large Aircraft Section, International Validation Branch, FAA; or EASA; or Airbus SAS's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature. \n\t(3) Required for Compliance (RC): Except as required by paragraph (i)(2) of this AD, if any service information contains procedures or tests that are identified as RC, those procedures and tests must be done to comply with this AD; any procedures or tests that are not identified as RC are recommended. Those procedures and tests that are not identified as RC may be deviated from using accepted methods in accordance with the operator's maintenance or inspection program without obtaining approval of an AMOC, provided the procedures and tests identified as RC can be done and the airplane can be put back in an airworthy condition. Any substitutions or changes to procedures or tests identified as RC require approval of an AMOC. \n\n(j) Related Information \n\n\n\tFor more information about this AD, contact Vladimir Ulyanov, Aerospace Engineer, Large Aircraft Section, International Validation Branch, FAA, 2200 South 216th St., Des Moines, WA 98198; telephone and fax 206-231-3229; email [email protected]. \n\n(k) Material Incorporated by Reference \n\n\n\t(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service informationlisted in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. \n\t(2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise. \n\t(i) European Union Aviation Safety Agency (EASA) AD 2021-0071, dated March 12, 2021. \n\t(ii) (Reserved) \n\t(3) For EASA AD 2021-0071, contact EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; telephone +49 221 8999 000; email [email protected]; internet www.easa.europa.eu. You may find this EASA AD on the EASA website at https://ad.easa.europa.eu. \n\t(4) You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. This material may be found in the AD docket at https://www.regulations.gov by searching for and locating Docket No. FAA-2021-0266. \n\t(5) You may view this material that is incorporated by reference at the NationalArchives and Records Administration (NARA). For information on the availability of this material at NARA, email [email protected], or go to https://www.archives.gov/federal-register/cfr/ibr-locations.html. \n\n\n\tIssued on April 1, 2021. Lance T. Gant, Director, Compliance & Airworthiness Division, Aircraft Certification Service. (FR Doc. 2021-07288 Filed 4-6-21; 11:15 am) BILLING CODE 4910-13-P

Related safety bulletins advice on the same designs, not orders

2017-07-19NM-17-20 · Equipment/Furnishings
2009-06-01NM-09-33 · Flight Control Primary Computer (FCPC)
2008-12-11NM-09-03 · Engine Fuel and Control - Implementing Fuel Tank System Airworthiness Limitations
2008-09-03NM-08-43 · Cabin Equipment/Furnishings - Seats
2008-07-02NM-08-31 · Equipment/Furnishings: Non-Textile Floors

Source: FAA Dynamic Regulatory System, airworthiness directives. The FAA's document is the authority; the register counts are this site's, from the FAA register of November 19, 2026. Connections as data: /graph/directive/2021-08-09.json · aircraft systems.

Aircraft

By kindModelsMakersEnginesFleetsWhat changed

Fly

Plan a flightAirportsLive mapRoutes and flightsFuels

Training and work

TrainingFlight schoolsGround schoolsPilot examinersMedical examinersJobs

Companies

DirectoryCharter operatorsFBOsRepair stationsClaim your listing

Safety and data

AccidentsRecords checkAnalyticsSAFxCHANGEThe graphAbout

Colours follow your device's light or dark setting.