2014-26-10: Time Limits/Maintenance Checks

Adoption of the Amendment Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD): 2014-26-10 Airbus: Amendment 39-18061. Docket No. FAA-2014-0526; Directorate Identifier 2013-NM-141-AD. (a) Effective Date This AD becomes effective February 25, 2015. (b) Affected ADs None. (c) Applicability This AD applies to Airbus Model A318-111, -112, -121, and -122 airplanes; Model A319-111, -112, -113, -114, -115, -131, -132, and - 133 airplanes; Model A320-111, -211, -212, -214, -231, -232, and - 233 airplanes; and Model A321-111, -112, -131, -211, -212, -213, - 231, and -232 airplanes; certificated in any category;all manufacturer serial numbers. (d) Subject Air Transport Association (ATA) of America Code 05, Time Limits/ Maintenance Checks. (e) Reason This AD was prompted by a determination that the maintenance actions for airplane systems susceptible to aging must be mandated. We are issuing this AD to mitigate the risks associated with the aging effects of airplane systems. Such aging effects could change the characteristics leading to an increased potential for failure, which could result in failure of certain life-limited parts, and could reduce the structural integrity of the airplane or reduce the controllability of the airplane. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Maintenance or Inspection Program Revision Within 30 days after the effective date of this AD: Revise the maintenance or inspection program, as applicable, to incorporate Airbus A318/A319/A320/A321 Airworthiness Limitations Section, ALS Part 4, ``Aging Systems Maintenance,'' Revision 01, dated June 15, 2012. The initial compliance time for doing the actions is at the applicable time specified in Airbus A318/A319/A320/A321 Airworthiness Limitations Section, ALS Part 4, ``Aging Systems Maintenance,'' Revision 01, dated June 15, 2012; or within 2 weeks after revising the maintenance or inspection program; whichever occurs later. (h) No Alternative Actions or Intervals After accomplishing the revision required by paragraph (g) of this AD, no alternative actions (e.g., inspections) or intervals may be used unless the actions or intervals are approved as an alternative method of compliance (AMOC) in accordance with the procedures specified in paragraph (i) of this AD. (i) Other FAA AD Provisions The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, FAA, has the authority to approve AMOCs for this AD,if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Branch, send it to ATTN: Sanjay Ralhan, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; telephone 425-227-1405; fax 425-227-1149. Information may be emailed to: [email protected]. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/ certificate holding district office. The AMOC approval letter must specifically reference this AD. (2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, InternationalBranch, ANM-116, Transport Airplane Directorate, FAA; or the European Aviation Safety Agency (EASA); or Airbus's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature. (j) Related Information Refer to Mandatory Continuing Airworthiness Information (MCAI) EASA Airworthiness Directive 2013-0146, dated July 16, 2013, for related information. This MCAI may be found in the AD docket on the Internet at http://www.regulations.gov/#!documentDetail;D=FAA-2014- 0526-0003. (k) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. [[Page 2815]] (2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise. (i) Airbus A318/A319/A320/A321 Airworthiness Limitations Section, ALS Part 4, ``Aging Systems Maintenance,'' Revision 01, dated June 15, 2012. The revision level of this document is identified on only the title page and in the Record of Revisions. The revision date is not identified on the title page of this document. (ii) Reserved. (3) For service information identified in this AD, contact Airbus, Airworthiness Office--EIAS, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France; telephone +33 5 61 93 36 96; fax +33 5 61 93 44 51; email [email protected]; Internet http://www.airbus.com. (4) You may view this service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221. (5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.