2014-10-02: Time Limits

Adoption of the Amendment Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by removing Amendment 39-14624 (71 FR 32268; June 5, 2006) and adding the following new AD: 2014-10-02 Dornier Luftfahrt GmbH: Amendment 39-17849; Docket No. FAA-2013-1056; Directorate Identifier 2013-CE-046-AD. (a) Effective Date This airworthiness directive (AD) becomes effective July 28, 2014. (b) Affected ADs This AD supersedes AD 2006-11-19, Amendment 39-14624 (71 FR 32268; June 5, 2006). (c) Applicability This AD applies to Dornier Luftfahrt GmbH Dornier Models 228- 100, 228-101, 228-200, 228-201, 228-202, and 228-212 airplanes, all serial numbers, certificated in any category. (d) Subject Air Transport Association of America (ATA) Code 5: Time Limits. (e) Reason This AD was prompted by mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as chafed or damaged wiring on the flight deck overhead panels (5VE and 6VE). We are issuing this AD to prevent chafing and damage to the wiring in the flight deck overhead panels, which could result in short- circuiting of related wiring and possibly lead to electrical failure of affected systems and potential fire in the flight deck. (f) Actions and Compliance Unless already done, do the following actions in paragraphs (f)(1) through (f)(3) of this AD: (1) Within the next 600 hours time-in-service (TIS) after July 28, 2014 (the effective date of this AD) or within the next 12 months after July 28, 2014 (the effective dateof this AD), whichever occurs first, and repetitively thereafter at intervals not to exceed 600 hours TIS or 12 months, whichever occurs first, inspect the wiring in the flight deck overhead panels, 5VE and 6VE, for chafing, damage, and/or incorrect installation (wire tie attachment holders). For the inspection, refer to: (i) Zone 321 on page 5, dated May 1, 2006, in section 05-22-10, Zonal Inspection Program, in Chapter 05, Time Limits/Maintenance Checks--General, in RUAG Aerospace Services GmbH Dornier 228 Time Limits/Maintenance Checks Manual (TLMCM), TM-TLMCM-090305-ALL, Revision 5, March 20, 2011; (ii) Zone 321 on page 5, dated May 1, 2006, in section 05-26-10, Low Utilization Zonal Inspection Program, in Chapter 05, Time Limits/Maintenance Checks--General, in RUAG Aerospace Services GmbH Dornier 228 Time Limits/Maintenance Checks Manual (TLMCM), TM-TLMCM- 090305-ALL, Revision 5, March 20, 2011; (iii) Pages 1 through 10, Overhead Panel 5VE--Description, dated November 25,2009, in subject 31-10-07, of Chapter 31, Indicating/ Recording Systems, in RUAG Aerospace Services GmbH Dornier 228 Airplane Maintenance Manual, TM-AMM-228-00014-080184, Revision 3, October 30, 2012; (iv) Pages 201 through 208, Overhead Panel 5VE--Maintenance Practices, dated November 25, 2009, in subject 31-10-07, of Chapter 31, Indicating/Recording Systems, in RUAG Aerospace Services GmbH Dornier 228 Airplane Maintenance Manual, TM-AMM-228-00014-080184, Revision 3, October 30, 2012; (v) Pages 1 and 2, Overhead Panel 6VE--Description, in subject 31-10-08, dated November 25, 2009, of Chapter 31, Indicating/ Recording Systems, in RUAG Aerospace Services GmbH Dornier 228 Airplane Maintenance Manual, TM-AMM-228-00014-080184, Revision 3, October 30, 2012; (vi) Pages 201 through 204, Overhead Panel 6VE--Maintenance Practices, in subject 31-10-08, dated November 25, 2009, of Chapter 31, Indicating/Recording Systems, in RUAG Aerospace Services GmbH Dornier 228 Airplane MaintenanceManual, TM-AMM-228-00014-080184, Revision 3, October 30, 2012. (2) If any chafed or damaged wires are found during any inspection required in paragraph (f)(1) of this AD, before further flight, repair the affected wire(s) and assure correct installation of the wiring in the flight deck overhead panels by reattaching or replacing the wire tie attachment holders and securing any loose wires to the wire tie attachment holders with plastic wire ties following: (i) Pages 1 through 10, Overhead Panel 5VE--Description, dated November 25, 2009, in subject 31-10-07, of Chapter 31, Indicating/ Recording Systems, in RUAG Aerospace Services GmbH Dornier 228 Airplane Maintenance Manual, TM-AMM-228-00014-080184, Revision 3, October 30, 2012; (ii) Pages 201 through 208, Overhead Panel 5VE--Maintenance Practices, dated November 25, 2009, in subject 31-10-07, of Chapter 31, Indicating/Recording Systems, in RUAG Aerospace Services GmbH Dornier 228 Airplane Maintenance Manual, TM-AMM-228-00014-080184, Revision 3, October 30, 2012; (iii) Pages 1 and 2, Overhead Panel 6VE--Description, in subject 31-10-08, dated November 25, 2009, of Chapter 31, Indicating/ Recording Systems, in RUAG Aerospace Services GmbH Dornier 228 Airplane Maintenance Manual, TM-AMM-228-00014-080184, Revision 3, October 30, 2012; (iv) Pages 201 through 204, Overhead Panel 6VE--Maintenance Practices, in subject 31-10-08, dated November 25, 2009, of Chapter 31, Indicating/Recording Systems, in RUAG Aerospace Services GmbH Dornier 228 Airplane Maintenance Manual, TM-AMM-228-00014-080184, Revision 3, October 30, 2012. (3) To comply with the actions of this AD, you may insert a copy of this AD or a copy of the required actions of this AD into the instructions for continued airworthiness section of the FAA-approved maintenance program (e.g., maintenance manual). This action may be done by an owner/operator (pilot) holding at least a private pilot certificate and must be entered into the airplane recordsshowing compliance with this AD in accordance with 14 CFR 43.9 (a)(1)(4) and 14 CFR 91.417(a)(2)(v). The record must be maintained as required by 14 CFR 91.173 or 135.439. (g) Other FAA AD Provisions The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, Standards Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Karl Schletzbaum, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4146; fax: (816) 329-4090; email: karl.schletzbaum@faa.gov. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (h) Related Information Refer to MCAI European Aviation Safety Agency (EASA) AD No.: 2013-0244, dated October 4, 2013, for related information. You may examine the MCAI on the Internet at http://www.regulations.gov/#!documentDetail;D=FAA-2013-1056-0002. (i) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. [[Page 35488]] (2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise. (i) Chapter 05, Time Limits/Maintenance Checks--General, in RUAG AerospaceServices GmbH Dornier 228 Time Limits/Maintenance Checks Manual (TLMCM), TM-TLMCM-090305-ALL, Revision 5, March 20, 2011: (A) Page 5, in section 05-22-10, Zonal Inspection Program, dated May 1, 2006; (B) Page 5, in section 05-26-10, Low Utilization Zonal Inspection Program, dated May 1, 2006. (ii) Chapter 31, Indicating/Recording Systems, in RUAG Aerospace Services GmbH Dornier 228 Airplane Maintenance Manual, TM-AMM-228- 00014-080184, Revision 3, October 30, 2012: (A) Pages 1 through 10, Overhead Panel 5VE--Description, in subject 31-10-07, dated November 25, 2009; (B) Pages 201 through 208, Overhead Panel 5VE--Maintenance Practices, in subject 31-10-07, dated November 25, 2009; (C) Pages 1 and 2, Overhead Panel 6VE--Description, in subject 31-10-08, dated November 25, 2009; (D) Pages 201 through 204, Overhead Panel 6VE--Maintenance Practices, in subject 31-10-08, dated November 25, 2009. (3) For service information identified in this AD, contact RUAG AerospaceServices GmbH, Dornier 228 Customer Support, P.O. Box 1253, 82231 Wessling, Germany; telephone: +49 (0) 8153-30 2220; fax: +49 (0) 8153-30 4258; email: custsupport.dornier228@ruag.com; Internet: http://www.ruag.com/en/Aviation/Aviation_Home. (4) You may view this referenced service information at the FAA, Small Airplane Directorate, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call (816) 329-4148. (5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.