Stinson 108 accident near West Creek, New Jersey, May 17, 2017

The NTSB's narrative final · quoted from the NTSB record

The private pilot reported that, while en route on a cross-country flight, the engine began to "shake." The pilot attempted to return to the airport; however, the engine experienced a total loss of power. The pilot subsequently initiated an emergency descent; however, the airplane struck trees and terrain about 1 mile from the approach end of the runway. The crankshaft and remaining cylinders remained intact, and the engine crankshaft rotated smoothly when the propeller was turned by hand. The No. 4 cylinder's exhaust pushrod shroud and exhaust pushrod were both bent. An examination of the engine revealed that the No. 4 cylinder was fracture-separated from the crankcase. The piston, sections of the No. 4 cylinder, and sections of the crankcase were missing. The No. 4 exhaust valve stem was fractured about halfway along its length, and the fracture surface was consistent with reverse bending fatigue crack propagation, which typically results from a stuck valve. The lower half of the stem and face were missing. The No. 4 exhaust valve guide clearance was excessive, and the valve's guide and tip area contained carbon deposits. The cylinder walls contained circular gouges consistent with the exhaust valve face diameter. It is likely that the carbon deposits on the valve stem resulted in the valve getting stuck, which initiated the reverse bending fatigue crack and led to the exhaust valve face stem fracturing and dropping into the cylinder and the subsequent catastrophic engine failure. The engine maintenance records were incomplete and prevented a determination of when the last clearance check of the No. 4 cylinder was performed or when it was last overhauled/replaced.

The complete narrative as the NTSB published it. The NTSB's docket holds the report as a PDF and any photographs, statements and other documents from the investigation.